Velv’or Jnaja Cock Ring Review

3D printed designer cock rings, you say? Yes, this is Velv’or Jnaja! A stylish cockring with a perineum stimulator built in. It’s firm, rough and delicious. But how does it fear when put to the test?

Jnaja is made with 3D printed nylon fibers, and apparently dyed so it will eventually show wear in the same way as raw denim would. This makes it a very unique and personal product, as the appearance changes to suit the wearer. I haven’t used mine enough to get any wear to show as of yet, though.

While the cock ring is rigid, it is surprisingly light. It feels almost like driftwood in a way. I find it very nice. The surface is a bit rough as the lines from the 3D printing are still present in some places. It does not cause any issues in use, so no matter.

The Jnaja is dead simple to use. The penis is pulled through followed by the balls, one testicle at a time. The pointed end is supposed to be at the bottom pointing towards the butt. This ensures that it rests on the perineum, which for some will feel quite nice. For me it doesn’t do much other than making its presence known.

Combined with an erectio, Jnaja is allowed to really do its thing. Being a non-flexible ring means it traps blood in the penis quite effortlessly as long as it’s in the correct size. Resulting in a raging hard-on and strutting balls. This in turn offers heightened sensitivity and pleasure while keeping the erection in tip top shape throughout the act. The rounded edges of the ring are always comfortable, and I barely feel that I have a ring down there. Sure I can feel it, but it’s not like it grabs my attention in any way once it’s in place.

Velv’or Jnaja

The gently curved shape rests comfortably against the skin and follows the contours of the body. It feels surprisingly well designed and as such is totally fine to wear for an extended amount of time. Please note though, that as with any ring it should not be used to keep an erection for more than 30 minutes. You are limiting blood flow after all.

I might have had a different (better?) experience if I hadn’t been such a wuss when it comes to firm rings. I opted for the larger size, rather than the one that could have been too tight. To ensure the correct fit – you measure around the penis and behind the balls all in one go. This is done while erect. It’s important to tighten well (but still keeping it comfortable), until the penis has clearly grown because of the pressure. That length is then divided by 3.14 – and there you have the diameter size the ring should be. I’d recommend taking off ~10mm from the total to ensure a tight fit.

I went with the 55mm model because I ended up at almost 60mm when measuring, and that felt pretty tight. I think the 50mm one would be a better fit though, and I will update this review if I get the chance to try it at a later point.

Overall I find that the Velv’or Jnaja is a great cock ring, and one of the more comfortable ones I have tried. It is easy to put on (probably because I could have used one of the smaller size) and just as easy to get off when allowed to relax for a few moments. It doesn’t pinch or rub uncomfortably against the skin even though it’s slightly rough on the surface.

It helps maintain a massive erection and it increases the sensation of sexual stimulation quite a bit. With the slight pressure on the perineum as an added bonus. I haven’t seen many rings do this, but it feels nice as the ring nudges the nub into the perineum with each deep thrust. Oh, and it looks amazing too!

Great ergonomic design, easy to use and it does what it’s supposed to. The perineum stimulator is nice, but not extraordinary. Lightweight and comfortable, yet completely rigid.